Induced Draft Fans
We manufacture and suppliers of superior quality Induced Draft Fan commonly known as ID Fan are available in wide range of capacity and pressure at elevated temperature to exhaust or recalculate high temperature gases/flue gases. Induced Draft Fan can be used with Boiler, Oven, Furnace etc. Induced blower fan is available in direct driven and V-Belt driven. The Plug Fan is used to recalculate in oven to achieve require temperature. The drive and material of construction are based on operating temperature.
Induced Draft (ID) fan are used to create a vacuum or negative air pressure in a system or stack. Our centrifugal blowers are used to maintain elevated ventilation, resulting in increased system efficiency. Teral-aerotech fan also suppliers extractor fans, which are typically heavy duty construction to handle particulate in the air stream. In the boiler industry induced draft fans are often used in conjunction with induced draft fan to maintain system pressure which is slightly lower than ambient.
Induced draft fan is also used to identify the combustion process used in large boilers. When mechanical ventilation is supplied to these boilers, the heat transfer rate increases. Induced draft fan or induced draft fans is always located between dust collector and chimney. Induced draft fan takes the hot flue gases from furnace via dust collector (dust separation system or Fume Extraction system) and will deliver to chimney. Induced draft fans produce the pressure lower than the atmospheric pressure in the system or we may say that Induced draft fan produces the negative pressure in the furnace to remove the flue gases from furnace via Multi Cyclone and to push the flue gases to chimney.
Induced Draft Fan Features:
- Capacity up to 80,000 CMH
- Static Pressure up to 350 mm WG (3500Pa)
- Temperature range to 500Â° C
- Cooling Disc and Radiation available.